TROUBLESHOOTING: OCT mount falls off the disc

Sad mount misses his disc.

Sometimes, when you're making rough cuts or even just regular cuts, the OCT mount gets knocked off the disc. This can be caused by several things, the most common reason being:

-You took too much time putting the mount together.
Once you get the disc onto the cold bar, you need to apply OCT immediately, before the disc has a chance to get too cold. If you take too long, the pre-chilled disc will freeze the OCT before it has a chance to ooze into those tiny nooks, crannies, and holes.

You can preheat your discs on the hotplate to give yourself a few seconds leeway and some burned fingers.

The most reliable way to make sure your mounts stay on the disc is to touch the tip of the OCT bottle to one of the holes and give it a good squeeze to force the OCT into the hole.

In figure A, the OCT froze before getting into the holes, making it the type that's likely to fall off the disc. You want the OCT to freeze inside the holes as shown in B, C, or D.

Other reasons why your mounts are getting knocked off the discs:

-The surface of the disc needs to be roughed up. Refer to the post below. 
-There are loose screws.  Check the knife screws, blade screws, etc. Check everything!
-Your cryo has been off for several hours and is too warm to cut on.  The OCT block isn't frozen solid enough to hold on to the disc. Bend a Freeze-It straw so that you can freeze the backside of the disc as well as the front.
-Your rough cuts are too aggressive.  When you're advancing the wheel by hand (e.g. cutting through the safety layer), avoid cutting too deeply with each turn.